Probes
Scope of the Art
Passive probes
Passive probes are suited for general measurements on low-frequency signals with less stringent accuracy requirements. A passive probe for each oscilloscope channel is included as standard equipment (RTx-ZP10). Passiv high-voltage probes are required for voltages above 400 V.
- Following models are available:
| Model | Bandwidth | recommended for |
|---|---|---|
| 500 MHz | ||
| 500 MHz | ||
| 400 MHz | ||
| 400 MHz |
Active probes
Active probes are required whenever the load on the device under test must be low, or when the measurement signal contains high-frequency components that should not be distorted. Even signals in the kilohertz range can contain high-frequency components of well over 100 MHz on their edges. Rohde & Schwarz offers an entire family of high-quality active single-ended and differential probes.
- Following models are available:
| Model | Bandwidth | recommended for |
|---|---|---|
| 1 GHz | ||
| 1 GHz | ||
| 1.5 GHz | ||
| 3 GHz | ||
| 1.5 GHz | ||
| 3 GHz |
Highlights
Current Probes
Current probes measure the current that flows through a wire. The R&S current probes are suitable for AC and DC current measurements.
- Following models are available:
| Model | Bandwidth | recommended for |
|---|---|---|
| 10 MHz | ||
| 100 MHz |
